collapse


* User Info

 
 
Welcome, Guest. Please login or register.
Did you miss your activation email?

* Who's Online


Dot Guests: 253 | Dot Users
Dot Hidden: 0

* Board Stats

  • stats Total Members: 12989
  • stats Total Posts: 130580
  • stats Total Topics: 18274
  • stats Total Categories: 5
  • stats Total Boards: 48
  • stats Most Online: 814

* Advertisers

Gear Pan
The lil Gold Spinner
BC GOLD
The lil Gold Spinner
The Pocket Sluice

Author Topic: Miller Tables  (Read 6803 times)

0 Members and 1 Guest are viewing this topic.

Offline Skymeat

  • Jr. Member
  • ***
  • Posts: 42
  • Province/State: Oregon
  • Kudos: 1
Miller Tables
« on: February 10, 2010, 06:56:48 PM »
I haven't seen this here.  Credit should go to Gary.  Best information that I have ever found about Miller tables.
~Skymeat~

Offline juu907

  • PPT Invited
  • *****
  • Posts: 2138
  • Kudos: 16
Re: Miller Tables
« Reply #1 on: February 17, 2010, 10:06:00 PM »
gary helped me a bunch. i built two this winter all with his help. wonder where he is havent seen any thing of him for some time now. cheerio

Offline J-Bear

  • J-Bear
  • PPT Invited
  • *****
  • Posts: 180
  • Province/State: BC
  • Country: ca
  • Kudos: 5
Re: Miller Tables
« Reply #2 on: November 26, 2010, 01:55:12 PM »

What slope should I set my Miller Table? 1-1/2" to foot? or other? I realize it is dependent on variable , gold shape, water flow etc but need a starting point.


Thanks

Offline Okie

  • CGPF Sponsor
  • *******
  • Posts: 165
  • Kudos: 4
    • Gold Cube
Re: Miller Tables
« Reply #3 on: November 26, 2010, 02:05:25 PM »
Start with your Miller table almost flat and set some material on it.. Slowly raise it until the light material starts to move.  At that point adjust your water flow high and low to see where the best action/retention is.  Now fine tune the slope from there.  An 1/8th of an inch can make a difference.  Make sure all the material is the same size.  No more than a variable of 2.  20mesh X 2 is 40 so you would need a 40 or smaller.  50 X 2 = 100 that is fine but I would still like to see one more step.  There are some 70 mesh by Jobe.  I use 8-12-20-30-50-70-100-200-400 Have fun.

Mike

Offline J-Bear

  • J-Bear
  • PPT Invited
  • *****
  • Posts: 180
  • Province/State: BC
  • Country: ca
  • Kudos: 5
Re: Miller Tables
« Reply #4 on: November 28, 2010, 03:32:40 PM »
Hello Okie ( Mike)

Thanks for the information on the miller table. I now have all the bits and pieces to put it together and your information really helped.

Tom

Offline jim1935

  • Member
  • **
  • Posts: 4
  • Kudos: 0
Re: Miller Tables
« Reply #5 on: December 30, 2010, 03:20:32 PM »
looking forward to building a miller table

 


Gear Pan
Gold Rat